While I display CONFIG page, buttons of FREQ+, FREQ-, RF PWR and OPER are still effective. Therefore it becomes BEACON mode when I push and hold OPER button for a few seconds, and the transmission is started at effective time. However, the CONFIG page is still displayed and cannot be closed. Is this right?
I tried QRSS and DFCW. It is easy to use it very much and is convenient. I liked in particular QSO mode in QRSS3/DFCW3 that I used JUMA TX136/TX500 Windows control software. http://www.jumaradio.com/juma-tx500/jum ... ntrol.html It was v1.06c, but was able to choose RF PWR MAX by this Windows software. Possibly is even beacon programming of QRSS/DFCW same?
Hi Patrick. I agree to your plan. The issue of modulation in WSPR was already removed in v1.06b. Therefore, I think that it does not have a big problem that TX500 user uses this version. I have the respect for you with big thanks. I will try this version on TX136. And I will continue feedback to you. Merry Christmas.
Hi Patrick, I have downloaded the juma-tx500.h(version 1.06c for Japan portable regulation) and programed it to JUMA TX500 using MPLAB and PICkit-3. It works well on my TX500. Thank you again. Rick - 7L1RLL
Hi Patrick, The test of v1.06b that I used TX136 and TX500 was finished all. I tried it including CW, QRS, DFCW of the beacon programming. There were not the new problems.
Hi Patrick, A note or explanation may be added on query in the wspr-users-guide_v106a.pdf. An example is shown bellow: ==== QUOTE ===== Programming WSPR parameters 1. Enter your standard callsign by entering "=WCMYCALL"<CR>. • The standard callsign can have 6 characters max. • Add-on prefix or suffix are not allowed. 2. Enter your 4-character maidenhead grid locator by entering "=WGGRID"<CR>. 3. Enter the dBm level for the TX136/500 power max by entering "=WPDB"<CR>. Note Current content can be viewed by "?WC"<CR>,"?WG"<CR> or "?WP"<CR> in addition to "?I"<CR> for query of information. ==== UNQUOTE ===== 73 Rick 7L1RLL