PA1000 firmware update failure
Posted: 25 Jun 2023 14:28
Good afternoon,
I am trying to upgrade my PA1000 from 1.33 to 1.35
Followed all the instructions at the firmware page, I have set the Ingenia bootloader (version 1.1) to run in Windows XP SP2 compatibilty mode and to run it as an administrator. Also copied ibl_dspiclist.xml from the website to the Ingenia folder.
Next, I shut down the PA1000 and start the bootloader. Serial port is COM4 at 9600 Baud which is a FT232 compatible USB to serial converter, works okay with my rig. When the detection starts I switch on the PA1000 and I get: dsPic identification failed, Error code: -5. Every time.
Can anyone point me in the right direction? The PC I am using is a DELL windows 10 laptop.
73 de Jo PG4I
I am trying to upgrade my PA1000 from 1.33 to 1.35
Followed all the instructions at the firmware page, I have set the Ingenia bootloader (version 1.1) to run in Windows XP SP2 compatibilty mode and to run it as an administrator. Also copied ibl_dspiclist.xml from the website to the Ingenia folder.
Next, I shut down the PA1000 and start the bootloader. Serial port is COM4 at 9600 Baud which is a FT232 compatible USB to serial converter, works okay with my rig. When the detection starts I switch on the PA1000 and I get: dsPic identification failed, Error code: -5. Every time.
Can anyone point me in the right direction? The PC I am using is a DELL windows 10 laptop.
73 de Jo PG4I