Page 1 of 1

TX500 Control board hardware?

PostPosted: 20 Sep 2017 18:15
by NE5U
I'm at the point where I need to mount the LCD and faceplate for the controller board. None of the hardware sizes makes sense. The small diameter screws are way too long (12mm) and stick out of the bottom of the board. The studs on the standoffs are way too long (8mm) and stick out of the board too far. Is that normal?

Re: TX500 Control board hardware?

PostPosted: 21 Nov 2017 21:32
by NE5U
Not much activity on this forum :/