TX136/500 V1.08 CWID and Script mode added
Posted: 11 May 2016 13:08
Hello the TX136/500 builders,
This new unofficial version 1.08 gives the following changes :
- CW identity option added : 12 or 24 wpm to accord with licensing conditions
- Script mode added : the serial control commands can be recorded and played to have a TX136/500 automation so as to create a different powers and modes beacon
- Possibility to play a carrier in an CW message
- Saving in the EEPROM reduced to preserve the byte endurance : If the jumper Q4 isn’t put, the Auto Power On parameter in the Service mode must be OFF to avoid an EEPROM saving at each beacon running
- Delay added during the scrolling of the characters list to make a choice easier in the configuration menu
- Some bugs fixed.
Having no TX500 this software has been validated on TX136.
If you update with this version don’t forget that the calibration values will be reset.
For the ones who will try it, thanks in advance for your feedback.
73, Patrick F4GCB
This new unofficial version 1.08 gives the following changes :
- CW identity option added : 12 or 24 wpm to accord with licensing conditions
- Script mode added : the serial control commands can be recorded and played to have a TX136/500 automation so as to create a different powers and modes beacon
- Possibility to play a carrier in an CW message
- Saving in the EEPROM reduced to preserve the byte endurance : If the jumper Q4 isn’t put, the Auto Power On parameter in the Service mode must be OFF to avoid an EEPROM saving at each beacon running
- Delay added during the scrolling of the characters list to make a choice easier in the configuration menu
- Some bugs fixed.
Having no TX500 this software has been validated on TX136.
If you update with this version don’t forget that the calibration values will be reset.
For the ones who will try it, thanks in advance for your feedback.
73, Patrick F4GCB