PA100-D Linear question

General discussion

PA100-D Linear question

Postby KD1NA » 29 Jul 2012 01:51

I am presently having a lot of fun building the PA100-D linear and have finished the control board and frequincy detection board. I am still building the rest of the linear and enjoying the challange of working with surface mounted components. I have powered up just the control module and it boots up fine, the display works perfectly and the front panel switches seem to be working. I am getting a flashing SWR alarm with beeps but I think that is because nothing is connected to this module at this time.

My question. What is the jumper configuration for J1 on the control board. I know it effects the secondary RS232 port that is not used but there is no information that I can find that indicates weather I need jumpers in J1 or not. Could someone please advise.
Thanks and 73
Dave KD1NA :geek:
KD1NA
 
Posts: 13
Joined: 25 Jul 2012 21:03
Location: USA

Re: PA100-D Linear question

Postby OH2NLT » 29 Jul 2012 17:21

Hello Dave
J1 in the control board is for second serial port connection.
http://www.jumaradio.com/juma-pa100/pa1 ... cs-b-2.pdf

Second serial port (UART2) is not used in the standard PA100-D firmware. You should leave all J1 pins open.

73 Juha oh2nlt
User avatar
OH2NLT
Moderator
 
Posts: 9
Joined: 11 Nov 2011 17:56
Location: Finland


Return to Juma Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron